View 3D-model

STIM320

STIM320 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit (IMU) with greatly improved accelerometer performance. It contains 3 highly accurate MEMS gyros and 3 ultra-high stability accelerometers. The IMU is factory calibrated and compensated for temperature effects over its entire operating temperature range.

STIM320 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM320 can offer.

ITAR free
Low gyro bias instability (0.4°/h)
Low gyro noise (0.10°/√h)
Low accelerometer bias instability (0.003mg)
Low accelerometer noise (0.015 m/s/√h)
±10g acceleration input range
User programmable bias trim offset
PPS input

Customer configurable output format, sampling rate and filter settings
Compensated digital output, RS422
Continuous self-diagnostics
Solid state - high reliability
Insensitive to magnetic fields
Weight: <0,13 lbs (<57g)
Volume: <2,2 cu. in. (35cm3)

How to buy

Documentation

STIM320 Product Brief

STIM320 Datasheet

Evaluation Kit STIM Products

STIM320 STIM380H EVK User Manual

Performance

Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The IMU runs off a single 5 V supply and communicates through a standard RS422 interface. For advanced users, STIM320 may be put in Service Mode. In this mode all the configuration parameters can be intermediately or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte. STIM320 also has a Bias Trim Offset function, allowing the user zero out any bias offset of all six axes individually. The bias offsets can be stored in the flash memory to remain in effect after powering off the IMU.

The STIM evaluation tool offer easy measurement and configuration access for STIM gyro modules and IMUs. The tool supports data sampling at alternative rates, graphical data presentation and data log to file for up to two gyro modules/IMUs in parallel. RS422 interface for PCI or USB, necessary cabling and PC software is included in the evaluation tool.